-
WarpAxe v0.1.18
Stablereleased this
2026-10-07 05:20:25 +00:00 | 426 commits to main since this releaseExperimental: the T-Display-S3 without an ASIC. The LilyGO T-Display-S3, the board NerdMiner runs on, now runs WarpAxe too, from the same image as every other board. It hashes on the ESP32-S3 itself: the chip's SHA unit on one core with a precomputed midstate, as NerdMiner v2 does, and a software loop on the other, together about 230 kH/s on USB power. That is a lottery ticket, not a miner. Thanks to BitMaker for the go-ahead.
- Installed with the web flasher only, and it stays at the version it was installed with: no online update, no upload. The flasher's full backup is the way back to NerdMiner.
- On the first start, a board on which nothing answers on the I²C bus and that still holds NerdMiner's settings becomes the T-Display-S3. It takes over Wi-Fi and wallet (worker
<wallet>.WarpMiner) and mines on WarpPool. Without NerdMiner's settings it is only offered in the board choice, never taken on its own. - The web UI and the display show kH/s, the ESP32-S3's temperature, shares per hour and the uptime. Hashing pauses at 85 °C and resumes at 75 °C.
- Nothing changes on boards with chips.
The update bar finishes on every network. After an online update the bar could stay at "Writing 100 %" although the miner had already restarted on the new version: a status request sent just before the restart could hang instead of failing, so the restart went unnoticed. Requests now give up after 4 s, and a miner that comes back with a new version counts as done. Since the bar runs in the page of the version you update from, this shows from the update after this one. Until then, a reload clears it. (Thanks John11.)
One image for every supported board:
warpaxe.bin,warpaxe.bin.sha256,warpaxe.bin.sig; for the first installwarpaxe-factory.binandweb-flasher.tar.gz(checksums ininstall.sha256).