• v0.1.22 d6a6266f66

    WarpAxe v0.1.22
    All checks were successful
    CI / Rust checks (push) Successful in 47s
    CI / Regulator scenarios (push) Successful in 49s
    Stable

    dvb-projekt released this 2026-10-08 14:56:29 +00:00 | 357 commits to main since this release

    New board: the NerdNOS (BM1397). WarpAxe now runs on the NerdNOS, the BM1397 carrier for the T-Display-S3 (rev 1.3), and with it on a third ASIC family: the BM1397 does not roll the version itself, so the ESP32-S3 computes four midstates per job. Against its stock firmware at 300 MHz the pool counted about 190 GH/s with WarpAxe and about 180 GH/s with the stock firmware, one hour each. The first start recognises the carrier by its thermistor and its 1.4 V core rail and takes over the NerdMiner wallet and Wi-Fi. Temperature comes from the thermistor, the power is an estimate (shown with "~"), and the clock is set by hand. After an overheat stop the chip comes back one clock step lower, until the next restart. Thanks to WantClue and Benjamin Wilson for the board and its firmware.

    Rollback of an update that does not start. A new image now boots on trial and marks itself good once the chips run, at the latest after three minutes. If the miner resets before that (a crash, the watchdog, a power cut), it goes back to the previous version, and the System page says so. This needs the new bootloader, which only a USB install writes: reinstall once with the web flasher (your settings are kept). Without it, everything works as before.

    Pool changes apply at once. A change to the main or fallback pool, the worker or the suggested difficulty now reconnects right away, no restart needed.

    Also in this release:

    • An open web UI tab reloads itself when the miner comes back on new firmware, wherever the update came from.
    • Every settings change is logged with the address it came from.
    • USB: the status shows "not connected" when the cable is pulled; the USB serial number is the device's MAC; a second WarpAxe on the same computer can get its own USB address (Network → USB address).
    • The chip difficulty starts at the profile's value and follows a lower pool difficulty only once that has settled, so a fresh connection does not flood the chips' answers.
    • T-Display-S3: the best difficulty keeps its decimals and survives restarts.
    • Settings on boards without a regulator or fan show only what is there; below 1 TH/s rates are shown in GH/s with two decimals.
    • New API fields: otaState, dieTempC, yieldPercent, clockStep, hasFan, hasVr, powerEstimated, usbSubnet.

    One image for every supported board: warpaxe.bin, warpaxe.bin.sha256, warpaxe.bin.sig, tested-on.txt; for the first install warpaxe-factory.bin and web-flasher.tar.gz (checksums in install.sha256).