-
WarpAxe v0.1.24
Stablereleased this
2026-10-09 15:17:56 +00:00 | 344 commits to main since this releaseNerdOS's chip init on the Nerd boards. On a NerdOctaxe-γ at 700 MHz, one hash domain of a chip sometimes stayed at about 3 % of its rate after a start, so the miner lost about 3 % until a power cycle. The cause was a single core-clock trim: ESP-Miner changed it in August 2026 (0x0C to 0x10, plus two new writes for its new boards), and WarpAxe took its init from there. NerdOS, which the Nerd boards were built and tuned with, keeps 0x0C. The BM1370 on the NerdQAxe++, NerdOctaxe and NerdQX now gets NerdOS's init. Bitaxe boards keep ESP-Miner's. On the bench the Octaxe came up with all 32 domains in 6 of 6 starts (restarts and chips off/on), against 2 of 6 with the old init.
Chips off as the stock firmware does it. On the NerdQAxe++ Rev 6, NerdOctaxe and NerdQX, "chips off" now follows NerdOS's shutdown, whether by hand, by an overheat stop or before a restart: the chain held in reset, the core rail off, the chips' I/O supply off half a second later, and the data line to the chips held low meanwhile. "On" follows NerdOS's bring-up order.
Also in this release:
- After a restart that was not a power-on, the chip supplies stay off at least five seconds before they come back.
docs/04describes the search step by step, with both bench rounds.
The API is unchanged.
One image for every supported board:
warpaxe.bin,warpaxe.bin.sha256,warpaxe.bin.sig,tested-on.txt; for the first installwarpaxe-factory.binandweb-flasher.tar.gz(checksums ininstall.sha256).