-
WarpAxe v0.1.4
Stablereleased this
2026-09-28 09:13:59 +00:00 | 76 commits to main since this release- Overheat: back on by itself. After an overheat stop the chips start again once chip and regulator are 10 °C below their limits and at least 60 s have passed; after a lost temperature sensor only with real readings back. The third stop within an hour stays off until it is cleared by hand. The API reports
overheatTripsandoverheatCause(hot or sensor), so a tuner can step the clock down instead of running the same point into the next stop. - Wi-Fi setup hotspot. With no network in the settings, or none reached within three minutes of a start, the miner opens
WarpAxe-XXXX: WPA2, with a ten-digit password made at every start and shown only on the device display. A phone that joins it gets the Wi-Fi setup page by itself; after saving, the miner restarts, joins the network and closes the hotspot. - Download mode button under System, for a reinstall with the web flasher at warppool.org/warpaxe.
- Fixed: chips going silent after some block changes (seen on the 4-chip NerdQAxe++ on Stratum V2): the work of a new block could be retired twice, so the chips idled for up to 30 s.
- Fixed: a wrong password at the hotspot aborted the firmware (an ESP-IDF 5.3 Wi-Fi event unknown to esp-idf-svc 0.51, patched in
vendor/esp-idf-svc). - The log names the address behind every restart, download-mode and overheat-reset request.
- New texts reviewed by native speakers in all eight UI languages and the six display languages.
One image for every supported board:
warpaxe.bin,warpaxe.bin.sha256,warpaxe.bin.sig; for the first installwarpaxe-factory.binandweb-flasher.tar.gz(checksums ininstall.sha256).Downloads
-
Source code (ZIP)
1 download
-
Source code (TAR.GZ)
1 download
- Overheat: back on by itself. After an overheat stop the chips start again once chip and regulator are 10 °C below their limits and at least 60 s have passed; after a lost temperature sensor only with real readings back. The third stop within an hour stays off until it is cleared by hand. The API reports