45 releases 94 tags

RSS feed

• v1.34.0 9b3c13f682

  Compare

  v1.34.0 Stable

  dvb-projekt released this 2026-09-27 12:10:44 +00:00 | 209 commits to main since this release

  Fixed

  • dvb-WarpTune energy mode: without the pool's energy feed a miner holds
    Eco, not Balanced — at a service start until the first reading, and
    when the feed goes stale. Without a reading the tariff may be the
    grid's; Balanced has no Eco cap, and after a start on 2026-09-27 an
    Avalon Q stepped up to Standard (~1370 W) in the three minutes before
    the feed arrived. The provisional start while surplus entry is being
    debounced is Eco as well.
  • dvb-WarpTune: a device that says its chips are off is held, not judged.
    The WarpAxe firmware can switch the chips off from its UI and reports it
    (shutdown, chainStopped, chainPhase other than READY); the zero
    draw and 0 mV core output looked exactly like a dead chip, which marks
    the step and everything above it for an hour and steps down. While any
    of these signals, overheat mode, a fault flag or a mining pause is set,
    nothing is marked or written, and once the device hashes again the
    point is judged from scratch. A chain in FAILED is not a stop on
    purpose and stays with the dead-chip guard, whose restart recovers it.
  • dvb-WarpTune on the Avalon Q: a work-mode switch is written as
    ascset|0,workmode,set,<n>. The MM firmware takes a verb after
    workmode (get reads, set writes) and refused the bare
    0,workmode,<n> with "workmode unknown argument", so no live switch
    had ever reached the device. Found on the first live write, 2026-09-26.
  • Stratum V1 and Sv2: a share on a job from before a block change is
    checked and booked for 60 s instead of being rejected as stale. A miner
    finishes the work it holds when the new block's notify arrives and hands
    in the results a few seconds later; that is real work, and dropping it
    showed up as a steady 1–3 % stale rate (a Bitaxe Gamma: one or two shares
    per block change, 2.7 % over 16 h). A block solution on such a job still
    goes to the node, which decides between the two blocks. After 60 s the
    job is stale as before. V1's duplicate check no longer resets on a block
    change, so a share handed in before and after the change still counts
    once (the set stays capped).
  • dvb-WarpTune voltage trial: the share vote now reaches back far enough
    to hold the 200 shares a verdict needs. VarDiff keeps every miner near
    four shares a minute, so the 30-minute window topped out around 130 and
    a voltage between 85 and 95 % of the expected rate waited for good (a
    NerdAxe Gaia at 420 MHz / 960 mV, 2026-09-26). The window is 30 minutes
    or 200 shares, whichever reaches further back.
  • dvb-WarpTune voltage trial: the pool's accepted shares decide a voltage
    verdict, not the firmware's hashrate reading. NerdOS does not see an
    undervolted chip: a NerdAxe Gaia read 103 % at 420 MHz / 940 mV and the
    trial walked on to 930 while the pool booked 70 % of the expected rate
    over 1739 shares (2026-09-25); the old rule called a point good when
    either vote said so. Where shares are counted, a voltage is good on 200
    shares at ≥ 95 %, short of good on 200 below it or on 40 when clearly
    short (under 85 %), and the point waits until the shares are in. A miner
    without a share counter is judged on the reading alone, as before.
  • dvb-WarpTune voltage trial: only failures at rising voltages count
    towards "more voltage does not help this frequency". A floor probed
    again is a floor: 930 mV failing three times at 420 MHz marked the
    frequency unstable although 940 and 960 hashed, and the miner spent the
    evening at 400 MHz. A good verdict resets the count.

  Added

  • dvb-WarpTune: dvb-warppool-tune yield --host <miner>, the yield table.
    For every ladder point the miner visited in the last week it lists the
    minutes, the pool's accepted shares and their difficulty (turned into a
    share-derived TH/s with its 1/√shares error), the firmware's expected
    hashrate, the mean draw from the heartbeats and the J/TH — over every
    visit, settle minutes skipped, windows before a device change or a
    start with another chip discarded. Below the table the point each mode
    should run: Max the most hashes, Eco the fewest J/TH, Standard the most
    hashes within 5 % of Eco's efficiency; a point needs --min-shares
    (200) to be picked, and Max says when the runner-up is within the
    error. The regulator's ten-minute judge is a safety net, not a way to
    tell 700 MHz at 1210 mV from 700 MHz at 1160 mV; the first run on the
    Octaxe did (26 665 shares: 11.62 TH/s at 1210, 102 % of expected).
    --json for scripts.

  ---

  dvb-WarpPool v1.34.0 — Downloads

  Docker

  git.warppool.org/dvb-projekt/dvb-warppool:v1.34.0 (multi-arch amd64+arm64, ohne v-Präfix)

  Native packages

  • Linux .deb: amd64 + arm64 → apt install ./dvb-warppool_*.deb
  • Linux .rpm: amd64 + arm64 → dnf install ./dvb-warppool-*.rpm
  • Linux AppImage: x86_64 + aarch64 portable
  • Linux tarballs: x86_64 + aarch64 for manual installs
  • macOS .dmg: added shortly after publish (built separately) — or build from source
  • Windows .msi: paused since the forge migration (no Windows runner yet)

  Signatures

  • SHA256SUMS + cosign bundle (SHA256SUMS.bundle, project key)
  • SBOM (SPDX) for all dependencies

  Verify (project public key cosign.pub in the repo root):

  cosign verify-blob \
    --key cosign.pub \
    --bundle SHA256SUMS.bundle \
    SHA256SUMS
  sha256sum --check SHA256SUMS
  

  First-time setup: run dvb-warppool-setup for the first-run wizard.

  Downloads

  • Source code (ZIP)
    0 downloads
  • Source code (TAR.GZ)
    1 download

  ---

  • SHA256SUMS
    5 downloads · 2026-09-27 12:11:55 +00:00 · 1.2 KiB
  • SHA256SUMS.bundle
    5 downloads · 2026-09-27 12:11:55 +00:00 · 3.5 KiB
  • dvb-WarpPool-v1.34.0-aarch64.AppImage
    3 downloads · 2026-09-27 12:10:45 +00:00 · 22 MiB
  • dvb-WarpPool-v1.34.0-aarch64.dmg
    1 download · 2026-09-27 12:11:37 +00:00 · 25 MiB
  • dvb-WarpPool-v1.34.0-x86_64.AppImage
    2 downloads · 2026-09-27 12:10:45 +00:00 · 24 MiB
  • dvb-WarpPool-v1.34.0-x86_64.dmg
    0 downloads · 2026-09-27 12:11:44 +00:00 · 27 MiB
  • dvb-warppool-1.34.0-1.aarch64.rpm
    0 downloads · 2026-09-27 12:10:46 +00:00 · 17 MiB
  • dvb-warppool-1.34.0-1.x86_64.rpm
    0 downloads · 2026-09-27 12:10:46 +00:00 · 18 MiB
  • dvb-warppool-v1.34.0-aarch64-apple-darwin.tar.gz
    0 downloads · 2026-09-27 12:11:49 +00:00 · 22 MiB
  • dvb-warppool-v1.34.0-aarch64-unknown-linux-gnu.tar.gz
    0 downloads · 2026-09-27 12:10:46 +00:00 · 24 MiB
  • dvb-warppool-v1.34.0-x86_64-apple-darwin.tar.gz
    1 download · 2026-09-27 12:11:55 +00:00 · 24 MiB
  • dvb-warppool-v1.34.0-x86_64-unknown-linux-gnu.tar.gz
    0 downloads · 2026-09-27 12:10:46 +00:00 · 25 MiB
  • dvb-warppool_1.34.0-1_amd64.deb
    2 downloads · 2026-09-27 12:10:47 +00:00 · 17 MiB
  • dvb-warppool_1.34.0-1_arm64.deb
    0 downloads · 2026-09-27 12:10:47 +00:00 · 16 MiB
  • sbom.spdx.json
    1 download · 2026-09-27 12:10:47 +00:00 · 1.3 MiB