45 releases 94 tags

RSS feed

• v1.39.0 6aca39cc79

  Compare

  v1.39.0 Stable

  dvb-projekt released this 2026-10-10 15:55:42 +00:00 | 14 commits to main since this release

  Fixed

  • WarpTune: the voltage trial no longer ratchets a voltage up on noise. A
    share vote short of the bar by less than its own noise on the double
    window counts as a deficit only when the chip error rate on the point rose
    by more than one point over the point's baseline (the error rate of its
    last good verdict, or of the next voltage up at that clock) — with the
    chip error trigger off as well. With flat errors and no second witness the
    verdict is "noise, not a deficit": the point is good, the trial goes on
    down toward the lowest good voltage, and a calibrated voltage raised in
    operation steps back on such a vote as on a healthy one. Where the firmware
    reports no error rate, or no baseline is known, the double window decides
    as before. (NerdQAxe++ 2026-10-07 → 10-10: Eco 600 MHz walked 1140 → 1240
    mV in 10 mV steps on votes of 95 % over 400 at a flat 0.2 % error rate,
    +18 % power.) The baselines are read back from the journal at a start.

  Added

  • Devices: WarpTune vs. hand point — a tile above the device cards and a
    line on every WarpTune card show what the Eco setting saves (watts) and
    what the Max setting adds (hashrate) against each miner's hand point: the
    point it would run without WarpTune (stock in warptune.toml, or the point
    seen at the first start). Measured, not modelled: watts from the miner's
    own readings, hashrate from the pool's accepted shares, over every stay on
    the point in the last seven days (dvb-warppool-tune yield's table). A
    point counts from 200 shares and 30 minutes; below that the card says "not
    enough data" with the counts. A point the miner no longer visits (a hand
    point replaced by its calibrated voltage) is estimated from the
    best-measured point at the same clock, power by V², and marked "≈". The
    tooltip carries the hand point, "(= factory setting)" when it is the
    maker's default, the measurement behind each figure (shares, minutes, last
    stay) and the method; "±" is the share noise. The Avalon Q's work modes are
    named as such; work-mode miners are left out of the tile's percentages
    (their kilowatt would dominate them) but stay in its watt and hashrate
    sums, and the tile names the miner left out. Watts and hashrate only — no
    kWh or money figure. The sidecar (savings on the snapshot) recomputes
    every 30 minutes on its own task (a failed run keeps the last figures,
    shows the error and retries after five minutes); no change to
    warptune.toml is needed.

  ---

  dvb-WarpPool v1.39.0 — Downloads

  Docker

  git.warppool.org/dvb-projekt/dvb-warppool:v1.39.0 (multi-arch amd64+arm64, ohne v-Präfix)

  Native packages

  • Linux .deb: amd64 + arm64 → apt install ./dvb-warppool_*.deb
  • Linux .rpm: amd64 + arm64 → dnf install ./dvb-warppool-*.rpm
  • Linux AppImage: x86_64 + aarch64 portable
  • Linux tarballs: x86_64 + aarch64 for manual installs
  • macOS .dmg: added shortly after publish (built separately) — or build from source
  • Windows .msi: paused since the forge migration (no Windows runner yet)

  Signatures

  • SHA256SUMS + cosign bundle (SHA256SUMS.bundle, project key)
  • SBOM (SPDX) for all dependencies

  Verify (project public key cosign.pub in the repo root):

  cosign verify-blob \
    --key cosign.pub \
    --bundle SHA256SUMS.bundle \
    SHA256SUMS
  sha256sum --check SHA256SUMS
  

  First-time setup: run dvb-warppool-setup for the first-run wizard.

  Downloads

  • Source code (ZIP)
    1 download
  • Source code (TAR.GZ)
    1 download

  ---

  • SHA256SUMS
    0 downloads · 2026-10-10 15:56:40 +00:00 · 1.2 KiB
  • SHA256SUMS.bundle
    0 downloads · 2026-10-10 15:56:40 +00:00 · 3.8 KiB
  • dvb-WarpPool-v1.39.0-aarch64.AppImage
    0 downloads · 2026-10-10 15:55:43 +00:00 · 23 MiB
  • dvb-WarpPool-v1.39.0-aarch64.dmg
    1 download · 2026-10-10 15:56:46 +00:00 · 26 MiB
  • dvb-WarpPool-v1.39.0-x86_64.AppImage
    0 downloads · 2026-10-10 15:55:43 +00:00 · 24 MiB
  • dvb-WarpPool-v1.39.0-x86_64.dmg
    1 download · 2026-10-10 15:56:52 +00:00 · 28 MiB
  • dvb-warppool-1.39.0-1.aarch64.rpm
    1 download · 2026-10-10 15:55:44 +00:00 · 18 MiB
  • dvb-warppool-1.39.0-1.x86_64.rpm
    1 download · 2026-10-10 15:55:44 +00:00 · 19 MiB
  • dvb-warppool-v1.39.0-aarch64-apple-darwin.tar.gz
    1 download · 2026-10-10 15:56:57 +00:00 · 23 MiB
  • dvb-warppool-v1.39.0-aarch64-unknown-linux-gnu.tar.gz
    1 download · 2026-10-10 15:55:45 +00:00 · 24 MiB
  • dvb-warppool-v1.39.0-x86_64-apple-darwin.tar.gz
    1 download · 2026-10-10 15:57:02 +00:00 · 24 MiB
  • dvb-warppool-v1.39.0-x86_64-unknown-linux-gnu.tar.gz
    1 download · 2026-10-10 15:55:45 +00:00 · 25 MiB
  • dvb-warppool_1.39.0-1_amd64.deb
    0 downloads · 2026-10-10 15:55:45 +00:00 · 18 MiB
  • dvb-warppool_1.39.0-1_arm64.deb
    1 download · 2026-10-10 15:55:45 +00:00 · 17 MiB
  • sbom.spdx.json
    0 downloads · 2026-10-10 15:55:46 +00:00 · 1.3 MiB